To install PD Slinks without the bumpers so you can bring the slider down to the base of the risers you will want to tack the tab inside the riser.
Assemble the Slink normally with two passes through the lines/riser. Position the tab centered inside the riser and push toward the top of the riser. Continue reading →
The PD Slink bumpers keep the tab hidden in the risers, keeps the slider at the top of the risers after deployment and focuses wear on the bumper instead of the riser.
Put the bumper over the riser and open up a pathway with your fingers for the Slink to pass through the riser.
Route the Slink through the line group (in the correct continuity) and the riser twice. Routed the end of the Slink through the hole at the hole at the bottom of the tab and then insert the tab through the loop at the end of the Slink. This creates a larks head knot. Pull tight and hide the tab inside the riser. Continue reading →
