PD Slinks: Installation without Bumpers

Assemble the Slink normally with two passes through the lines/riser. Position the tab centered inside the riser and push toward the top of the riser. Take a hand needle that is not damaged and pass a piece of super tack through the riser to one side of the center line of the riser, through the tab and out the opposite side. Bring the needle and super tack back through from the other side. Tie a double-overhand knot followed by a single-overhand knot. Hint: Use your needle to bring the tails of the super tack into the center of the riser and out the side. Trim and your tails are hidden. To purchase PD SLinks, see our listings at ChutingStar.com at this link.