The PD Slink bumpers keep the tab hidden in the risers, keeps the slider at the top of the risers after deployment and focuses wear on the bumper instead of the riser.
Put the bumper over the riser and open up a pathway with your fingers for the Slink to pass through the riser.
Route the Slink through the line group (in the correct continuity) and the riser twice. Routed the end of the Slink through the hole at the hole at the bottom of the tab and then insert the tab through the loop at the end of the Slink. This creates a larks head knot. Pull tight and hide the tab inside the riser.
Hint: On the second pass through the riser, use a Power Tool or smooth hemostat to bring the Slink through. It’s a smaller hole on the second pass and can be difficult just with your hands.
To purchase PD SLinks, see our listings at ChutingStar.com at this link.
To purchase PD SLinks, see our listings at ChutingStar.com at this link.