ChutingStar Skydive & Skate Gear Superstore!
Looking for the Skate Shop?
Rev2 Replacement Lens
Pro-Tec Fullcut Replacement Liner
Bonehead Rev2 Contour Rail Helmet Mount
Exo Hard Helmet Case
Pro-Tec Classic Skate PLUS Helmet Liner
Bonehead Rev2 GoPro Helmet Mount
G3/G2 Dual Camera Mounting Platform
Cookie FlySight Mount
EVO Double Ratchet Chincup
Replacement Liner for Cookie FUEL
Cookie Fuel Audible Mount Spare Parts Kit
Cookie G3 GoPro Roller Mount
EVO FlySight Mount
EVO Button Cutaway Kit
EVO Carbon Top Mount & GoPro Attachments
Z-1 Frame, Lens, Bolts
Z-1 Skylight Polycarbonate Lens
Cookie Fuel Top Plate Camera Mounts
Cookie Fuel Side Plates
Cookie Cutaway Chinstrap
Replacement Liner for Atomic
Replacement Liner for Ozone
Pro-Tec Classic Skate Helmet Fit Kit
Pro-Tec Classic Skate Helmet Liner

Accessories

3 Item(s)

per page

Grid  List 

Set Descending Direction
Switch View
  • REvolve Contour Camera Mount

    REvolve Contour Camera Mount

    $60.00

    The REvolve Contour Camera Mount allows you to add the Contour series of cameras to the side of your helmet such as the Contour1080p, ContourGPS or Contour+. Bonehead Composites now offers a mounting solution for the contour camera and standard side mounts. Consists of a plastic Derlin plate and machined aluminum rail which slides into the contour rail guides and allows visor rotation and level adjustments. The REvolve Contour Camera Mount is sized per the shell/visor size. Select your REvolve size above when ordering. Note: Mount does not include Contour camera, which is available separately from ChutingStar.com. Mounting instructions 1. Remove original visor pin from the left side of the helmet. 2. Place a piece of masking tape over each raise mounting pad on the REvolve. 3. Using the longer pin supplied with the contour mount, slide the pin through the upper plate hole through the visor grommet and finally into the helmet and secure. 4. Rotate the plate, centering the middle or each lower mounting slots over the center of each mounting pad. Mark these locations with a pen and then check for center accuracy. 5. Using a 8/32 drill or Dremel tool drill the center marks through the helmet. 6. Secure the lower contour mount with supplied hardware with washers under both the screw head and nut. 7. Minor up/down adjustments can be obtain by loosening the lower screws and slightly rotating the plate to the fore or aft slot positions. Most sizes of the REvolve Contour Camera Mount are in stock for immediate shipment from ChutingStar.com.

    Learn More | Add to Wishlist | Add to Compare
  • Bonehead Concealed Chincup

    Bonehead Concealed Chincup

    $80.00

    The new Concealed Replacement Chincup Assembly from Bonehead Composites. This new chincup kit is made for replacements or retrofits of all Bonehead open-face helmets and can also be used on other manufacturer helmets. This updated concealed version featured a centered concealed pocket to hid the ends of the ladder straps. The padding is also removable for washing.

    Learn More | Add to Wishlist | Add to Compare
  • Replacement Top Plate for Flat-Top Pro

    Replacement Top Plate for Flat-Top Pro

    $66.00

    Replacement top plate for Flat-Top Pro. The top plates, by Bonehead Composites, are made of carbon fiber, and are available in three different sizes.

    Learn More | Add to Wishlist | Add to Compare

3 Item(s)

per page

Grid  List 

Set Descending Direction
Switch View