ChutingStar Skydive & Skate Gear Superstore!
Looking for the Skate Shop?
Bonehead Rev2 Contour Rail Helmet Mount
Bonehead Rev2 GoPro Helmet Mount
G3/G2 Dual Camera Mounting Platform
Garmin VIRB Adjustable Mounting Arms Kit
Garmin VIRB Vented Helmet Strap Mount
Garmin VIRB Mount Base Kit
EVO Tilting Top Mount
Drift Adhesive Mounting Kit
Zkulls HERO Overkill Slim Mount
Pivot Pad Helmet Mount System
Cookie G3 GoPro Roller Mount
Sony Action Cam Tilt Adaptor
Sony Action Cam Adhesive Mounts
EVO GoPro Helmet 3-Mount Combo Kit
EVO GoPro Long-Profile Front Helmet Mount
EVO GoPro Low-Profile Front Helmet Mount
EVO GoPro Curved Top Mount
EVO Carbon Top Mount & GoPro Attachments
Cookie Fuel Top Plate Camera Mounts
Cookie Fuel Side Plates
Replay XD HardCore Billet Tripod Mount
Replay SnapTray Adhesives
Replay Curved SnapTrays
Replay XD LowBoy Mount

Helmet Mounts

3 Item(s)

per page

Grid  List 

Set Descending Direction
Switch View
  • Bonehead Rev2 GoPro Helmet Mount

    Bonehead Rev2 GoPro Helmet Mount

    $40.00

    Bonehead Rev2 GoPro Helmet Mount.

    Learn More | Add to Wishlist | Add to Compare
  • Bonehead Rev2 Contour Rail Helmet Mount

    Bonehead Rev2 Contour Rail Helmet Mount

    $40.00

    Bonehead Rev2 Contour Rail Helmet Mount.

    Learn More | Add to Wishlist | Add to Compare
  • REvolve Contour Camera Mount

    REvolve Contour Camera Mount

    $60.00

    The REvolve Contour Camera Mount allows you to add the Contour series of cameras to the side of your helmet such as the Contour1080p, ContourGPS or Contour+. Bonehead Composites now offers a mounting solution for the contour camera and standard side mounts. Consists of a plastic Derlin plate and machined aluminum rail which slides into the contour rail guides and allows visor rotation and level adjustments. The REvolve Contour Camera Mount is sized per the shell/visor size. Select your REvolve size above when ordering. Note: Mount does not include Contour camera, which is available separately from ChutingStar.com. Mounting instructions 1. Remove original visor pin from the left side of the helmet. 2. Place a piece of masking tape over each raise mounting pad on the REvolve. 3. Using the longer pin supplied with the contour mount, slide the pin through the upper plate hole through the visor grommet and finally into the helmet and secure. 4. Rotate the plate, centering the middle or each lower mounting slots over the center of each mounting pad. Mark these locations with a pen and then check for center accuracy. 5. Using a 8/32 drill or Dremel tool drill the center marks through the helmet. 6. Secure the lower contour mount with supplied hardware with washers under both the screw head and nut. 7. Minor up/down adjustments can be obtain by loosening the lower screws and slightly rotating the plate to the fore or aft slot positions. Most sizes of the REvolve Contour Camera Mount are in stock for immediate shipment from ChutingStar.com.

    Learn More | Add to Wishlist | Add to Compare

3 Item(s)

per page

Grid  List 

Set Descending Direction
Switch View